Finding Flaws at Close Range

Bag Target - Basement Archery - 1

This weekend Pennsylvania was hit with snow. It came down fast and furious on Saturday, making travel a bit difficult. When Sunday rolled around the weather wasn’t bad but my little front wheel drive car left me feeling as though I was stuck in the house.

I wanted to take a ride over to Stowe Archers but the thought of climbing a snow covered hill brought back memories of last year when I went sliding down the hill, backwards.

Having the itch to shoot my bow, I improvised and hung a bag target in my basement. I was able to shoot from one corner of the building to the other. I was only able to manage about 25 feet but I thought it would be sufficient shooting at 1″ dots.

Shooting at close range allowed me to put less focus on my sight pin and allowed me to focus on form. After a few arrows I realized that I have a terrible habit that I need to work on breaking.

If my sight pin is high, I can easily settle down into the target and everything is fine. If I’m low and need to raise my bow arm, it feels like I’m trying to lift an anchor with my arm fully extended.

After struggling with getting my pins to rise, I have a tendency to cheat and manipulate the sight picture with my wrist. This leads to the sight pin sort of swooping into place, at which point target panic sets in and I punch the trigger.

At close range this leads to the arrow impacting upwards of two inches right. This explains my erratic 6’s and 7’s when shooting a 3-Spot Vegas target at 20 yards.

At some point I’d like to make the switch to a hinge release. I don’t think it will totally fix my trigger punch problem but I think it may help. I’ll have to keep an eye out on Archery Talk and see if I can find one with a safety. The last thing I want to do is punch myself in the face during leages at Stowe.

setFaceCropped54C53995-1083-09D4-8573-97CD6D3F2AD9

1 comments On Finding Flaws at Close Range

  • Walt the reason you can’t lift the pin is because your loop is too low. By raising it you change the leverage point of your bow and make it easier to lift. By the way you always want to raise your pin to target and even float the “X” on top of the pin “lollypop”. By lowering pin to target your always shooting down by the time the spot shows up on the mark. Remember the arrow angle on rest must still be right so you may need to raise it too, best shoot through paper to fine tune once loop center is right. We talked briefly about this and it is on the setup sheet I gave you some time ago. Good luck, it looks like your tightening your groups little steps to make big improvements.

Leave a reply:

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.